Same-Day Dispatch | Free Shipping (AUS orders over $100)

Guitar Fret Installation (0.5mm / 0.023 Cut)...

We are often asked if we have a Japanese hand saw capable of achieving an extremely accurate 0.5mm cut for the installation of frets into a guitar neck.

While we did have a few saws with this specification of kerf, we tested multiple units to see which performed best.

Long story short, our small Dozuki saw outperformed all others for this task, the MP150. We consistently measured 0.5mm when testing this saw, also being a "Dozuki" type pull saw (with a stiff, rigid spine), this model helped produce very straight cut lines. 

Check it out here...

 

ProTooling Australia

ProTooling.com.au Logo _Japanese Woodworking Tools, Chef Knives, Whetstones & Traditional Japanese Kitchen Knives

← Older Post Newer Post →



Leave a comment

Please note, comments must be approved before they are published